Montigo GTMS Anleitung zur Fehlerbehebung PDF herunterladen (Seite 6)

4 Tools

Manometer

Multimeter

Flat-head

Screwdriver

Phillips-head

Screwdriver

Test Wire

5 Troubleshooting

Before proceeding with the procedures in the following troubleshooting table, verify that the power

supply (AC/DC adapter or Fan Control Module) is present and that the batteries inside the receiver

and/or optional battery pack are fresh and installed with correct polarity.

Make sure all the connections between the wire harnesses and system components are proper

and positive.

Make sure the communication link between transmitter and receiver is established (see Operating

Procedure of 9957035 GTMF Installation manual).

Verify that the static inlet pressure meets the manufacturer’s recommended inlet pressure. If neces-

sary adjust the line pressure regulator.

If the recommended actions for the following troubleshooting ﬂ ow chart do not help to address the

problem consider replacing wiring harnesses.

See Troubleshooting ﬂ ow chart.

In case of doubt contact us before to proceed.

WARNING

Any actions performed on the gas valve must be performed in accordance with the gas

valve instruction manual. Likewise, any actions performed on the DFC or other system

components must be done in accordance with the with the individual component instruction

manuals.

Replacement of components must be performed in accordance with the manufacturer’s

instruction manual.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Keine Kommentare

Montigo GTMS Anleitung zur Fehlerbehebung Seite 6