Montigo L-Series DF Installationsanleitung Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 22
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
Page 11
L52-DF Gas Fireplace
Part No. XG0180
f i r e f e a t u r e
Installation
Rear Vent Venting Runs
The L52-DF, Rear Vent has only two possible installation in the rear vent
conguration, one 90degree elbow off the back and straight up through
the roof of the structure, or Figure 23 with two elbows.
Heat Shield
The heat shield (RHS101) must be used on all installations straight
through the wall, at the point where the vent pipe connects to the
termination. With the heat shield, proper vent clearances can be
maintained. The heat shield is not included with the replace.
To install the heat shield, slide one section over the vent pipe on the inside
of the wall opening, with the circular portion inside the wall cavity. Screw
the shield in place over the wall opening. Install the second section on
the outside of the wall opening sliding the circular portion into the wall
opening. Refer to Figure 19.
Figure 22c. Multi-Elbow Venting Graph.
Figure 23. Multi-elbow installation.
For L52DF distance 'H' must be a minimum of 50".The vent
run must comply with figure 22c.
NOTES:
All dimension lengths for vertical or horizontal runs are
measured from center of the vent pipe.
IMPORTANT: Venting runs must fall within the limits set
by the venting graph (see Figure 22c).
Installation Of Rear Vent DV
The following venting components are available for an L52-DF, in a
Rear Vent installation:
5" / 8" Venting
A - Termination
PTO-3 (3" Length)
PTO-3F (3" Length)
B - Stucco Kits
MSR (Stucco Frame)
BSR-4 (4" Brick Frame)
BSR-6 (6" Brick Frame)
MOSR (Stucco Can)
C - Flex Sections
PFL-1 (12" Section)
PFL-2 (24" Section)
PFL-3 (36" Section)
PFL-4 (48" Section)
D - Rigid
Sections
PEXT-1 (12" m/f Section)
PXT-20 (20" section)
PEXT-2 (24" m/f Section)
PEXT-3 (36" m/f Section)
PEXT-4 (48" m/f Section)
E - Elbows
PEL-90MM (m/m 90° Elbow)
PEL-90FF (f/f 90° Elbow)
PEL-90FM (f/m 90° Elbow)
PEL-45FM (f/m 45° Elbow)
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare